Emuge Corp., a manufacturer of a line of taps, thread mills, end mills, holders and attachments, has introduced the TiNox-Cut, a new series of end mills specifically developed to provide tool life when machining challenging materials. The TiNox-Cut End Mills offer a cutting solution for nickel alloys like Inconel and Stellite, all grades of titanium, and tough stainless steels like super duplex – materials used extensively in the aerospace, power generation, medical, chemical and food industries, among others. They feature a high heat-resistant, lubricious coating and an optimized cutting edge design. In addition, the tools are made from an extra-tough carbide grade to maximize wear resistance. They also feature reduced neck diameters and combine a tight, h5 shank tolerance with a specially roughened surface finish to maximize tool holder clamping potential. The end mills are suited for both roughing and finishing operations. The tools consist of three designs: two 4-flute variations for both roughing and finishing, and a 5-flute extra long finishing tool. TiNox-Cut roughing / finishing end mills are available with flat ends or with a selection of corner radii. TiNox 4-flute end mills are available with internal coolant / lubricant capability. The roughing / finishing versions are available with a serrated profile for effective chip breaking during roughing operations. Emuge TiNox-Cut End Mills range in diameter from 6mm – 20mm, depending on the design.